SHARPY C61375 Instruction Manual download pdf (Page 31)

SHARPY

405

(15.94")

330

(12.99")

345

(13.58")

185

(7.28")

475

(18.70")

(

11.02")

(17.72")

315

(

12.40")

Power supplies available

115/230V 50/60Hz

Input power:

350VA a 230V 50Hz.

Total output

Max 8000 lumens

Lamp:

amp system with a short arc burner in a reflector

Philips MSD Platinum 5R (L10103)

- Output Lamp power: 189W

- Colour temperature 8000 K

- Luminous flux 7950lm

- Average life 2000 h

- Any working position

sram Sirius HRI 190+ (LAM002)

- Output Lamp power: 190W

- Colour temperature 8200 K

- Luminous flux 8100lm

- Average life 3000h

- Any working position

Motors:

13 stepper motors, operating with microsteps,

totally microprocessor controlled.

Channels:

Max 20 control channels.

Inputs:

DMX 512

Ethernet

Movable body:

• Movement by means of two stepper motors,

controlled by microprocessor.

• Automatic repositioning of PAN and TILT after

accidental movement not controlled by control

unit.

• Travel:

- PAN = 540°

- TILT = 252°

• Maximum speeds:

- PAN = 2.45 sec

- TILT = 1.30 sec

• Resolution:

- PAN = 2.11°

- PAN FINE = 0.008°

- TILT = 0.98°

- TILT FINE = 0.004°

• Accuracy:

- Resolution ± 0,15° (Range 0,3°)

IP20 protection rating:

• Protected against the entry of solid bodies larger

han 12mm (0.47”).

• No protection against the entry of liquids.

CE Marking:

Complies with the following European Directives

- 2006/95/EC (LVD)

- 2004/108/EC (EMC)

- 2011/65/EU (RoHS).

Safety Devices:

• Bipolar circuit breaker with thermal protection.

• Automatic break in power supply in case of

overheating or failed operation of cooling system.

Cooling:

Forced ventilation with axial fans.

Body:

• Aluminium structure with die-cast plastic cover.

• Two side handles for transportation.

• Device locking PAN and TILT mechanisms for

transportation and maintenance.

Working position

Functioning in any position.

Weights:

about 19 Kg (41lbs 13ozs).

TECHNICAL INFORMATION

CAUSE AND SOLUTION OF PROBLEMS

THE PROJECTOR WILL NOT SWITCH ON

PROBLEMS

ELECTRONICS NON-OPERATIONAL

DEFECTIVE PROJECTION

REDUCED LUMINOSITY

POSSIBLE CAUSES CHECKS AND REMEDIES

No mains supply.

Lamp exhausted or defective.

Signal transmission cable faulty or disconnected.

Incorrect addressing.

Fault in the electronic circuits.

Lenses or reflector broken

Dust or grease deposited.

Check the power supply voltage.

Replace the lamp. (See instructions).

Replace the cables.

Check addresses (see instructions).

Call an authorised technician.

Clean (see instructions).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments

SHARPY C61375 Instruction Manual Page 31

Comments to this Manuals

Related products and manuals for Projectors SHARPY C61375